citrix receiver for mac invalid or missing certificate

Go to Web > General settings, and clear the check box 'Enable web content'.Large numbers of files that are of zero length don't cause the issue. Non-zero length files can take up a significant portion of the partition. If the availble space shows 0 MB, enter the following command: To determine if the issue affects the firewall, enter the following command: If web caching is turned on (Web > General settings > Enable web content cache) the /tmp directory may run out of space.

When you use the web proxy, files that undergo anti-virus scanning are stored in /tmp. WAF does not permit file uploads larger than 1 MB in OWA. You must use one of the tags, , or, after the tag. The names of physical and virtual interfaces, wireless networks, and IP tunnels can't start with system-reserved names, such as port, eth, ge, and xfrm, except when the Name is the same as the Hardware name. Unable to update interface name using the following terms: 'port', 'eth', or 'ge'. The other links don't connect because of authentication failure.Įdit the PPPoE interface configuration, update the password, and save the configuration. So, only one PPPoE link remains functional after migration. When more than one PPPoE link is configured on SFOS, and you upgrade the firmware to 18.5.MR2 build #380, passwords of the PPPoE links are lost for all but any one PPPoE link. If WAF does't start and reverseproxy.log shows the following message, contact Sophos Support: WAF may stop working after a backup is restored for firewalls that first started with a version earlier than 18.0 GA and are currently running a version later than 18.0 GA. The firewall then delivers spam instead of blocking or quarantining it. You'll see the message “spam scanning failed, unable to connect local antispam:” smtp_main.log shows the error “ng_buffer_read: reach buffer limit 2048”. The returned value includes the spam rule hits detected for the message itself. SASI engine fails if the returned value from the engine is larger than the buffer.

Set 'Interface speed' to '10000 Mbps - Full Duplex' for physical and LAG interfaces. XGS 10G interfaces don't work when Interface speed is set to Auto-negotiation for physical and LAG interfaces.Īffected platform: Only XGS Series hardware with 10G interface. See Upgrade to 19.0 GA results in factory reset. To retain the logs based on your previous selection, revert to your selection before midnight. The firewall deletes logs beyond the specified period at midnight.

Change the setting back to the previous selection if you want.

Change Retain SSL/TLS inspection logs of the past to 1 month.

To see the Log retention period, go to Reports > Show report settings > Data management and see Retain SSL/TLS inspection logs of the past.

Citrix receiver for mac invalid or missing certificate